1. Home
2. About G.R.I.M.E.X.
3. Combined shears type FP – 14

        The combined shears type F – 14 for different steel profiles, is used for:

• cutting to the wished length of the rolled forged pieces as: sheets, sections (U, L, T, I, round, square, hexagonal);
• cutting on the edge and perforations in the margins of the sections and sheets;
• circular or sectional cutting by crunching or cutting of the thin sheets.

            Within the machine there are combined the following working stations: Scissors for sheet, Scissors for rolled bars, Scissors for edge cutting, Scissors for sections, Punching, Crunching scissors.

            The machine may be used within two working regimes:

• single working regime (hit after hit);
• continuous working regime (repeated hits).

            Technical features:

• Maximal width of cut sheets: 14 mm;
• Maximal width of the cut rolled bars:
  • Round section: 45;
  • Square section: 40 mm.
• One cut rectangular cut: 90x50x10 mm;
• Number of double cuts / minute of the tool-post on the sheet: 63;
• Section cutting:
  • 90^o cutting for sections L, T: 120x120x12 mm;
  • 45^o leaned cutting for sections L, T: 80x80x10 mm.
• Number of double cuts / minute: 60;
• Perforating maximal diameter and width: 30x16 mm;
• Number of double cuts / minute for perforation: 66;
• Crunched sheet maximal width: 4 mm;
• Number of double cuts / minute for crunching: 1150/850;
• Dimensions:
  • Length: 1825 mm without the crunching tool;
  • Length: 3495 with the crunching tool;
  • Width: 825 mm;
  • Height: 2005 mm.
• Net weight: 2950 kg.

            NOTE: The cut values are presented for materials with Rm= 45 daN/cm².